0:00
So if your bottom loading water dispenser is blinking on and off red, it's time to change the
0:04
water. And today I'm going to show you how to replace the water with this five gallon jug
0:08
So starting at the bottom, this door is just going to open just like so. And here we can see
0:14
the five gallon jug is completely empty. There's no water left. So it did a really good job
0:19
sucking everything up. And the first thing to do is to pull this right out, lift this upwards
0:30
and this can come right out. Now before taking this out I want to prep my other water jug
0:40
If you want you can put this directly on top but it might not fit properly so the best
0:44
thing to do is to take this completely off. And I'm doing this very carefully just not
0:50
to spill the water. And now we can take this and insert it right here
0:59
Just push it all the way down And now this rubber part can be pushed down and this is going to be what tightens it So this part is really important and it to put it inside
1:09
here, but be very careful and just push it gently as to not spill anything. And because
1:14
there is an angle here, you can just push it upwards and it lifts right in just like
1:21
that. And so with the door open, the red light is still blinking on and off. There's no sound
1:26
coming out but when I close it it immediately starts working the red it goes away and it's
1:34
sucking the water upwards right now and if you have a loud annoying clinking sound in here
1:39
it might be because the tag was still attached and so I went ahead and took it off
1:46
and the noise disappeared and also right now it finished shaking so the water should be sucked up
1:52
into the reservoir over here. And here we could see the water level is no longer up to here
1:58
It's around right over here. And now we can get some nice cold water
