0:00
So Yahi Tech sent me this three-tier console table with metal and glass
0:04
So I just want to do a quick unboxing assembly and give my first impressions of this
0:09
So here's all the pieces it comes with. We got the glass tops, the metal legs, the metal frame, the hardware, and finally the instructions
0:18
So the first step is to attach all four legs to the frame. And we're going to be using this frame labeled 1, making sure that the three holes are facing upwards
0:26
And we're going to be using the screws and the baggie labeled A. And now the important part is to not screw them in all the way since we're going to go ahead and be putting the second frame up here in the next step
0:36
So here's what we get. And so the next step is to go ahead and screw in the frame label two, which is going to be this one right in the center here
0:44
And now there's no right or wrong way to put it, but I see that the welds are going to be facing here
0:49
So I want the welds to face downwards so it's not seen on top of the glass
0:53
So in other words, I'll face the welds up, which would be down because this is upside down
0:58
And we're going to be using the screws in the baggy labeled B. And now since I'm doing this myself, I went ahead and put two pillows, or actually three
1:04
pillows at the end over there to go ahead and support the weight. So when I go ahead and lift this side up, it'll go ahead and be leveled
1:18
And there, that's what it looks like. And the next part is to go ahead and get the top frame labeled three, and then go ahead
1:23
and put it on top, which is going to be this one over here. And then same thing, making sure that the welds are facing upwards
1:29
And we're also going to be using the same screws before labeled B. And now it's time to install the feet in the baggie labeled C
1:43
So before we flip this over, all the screws can go ahead and be tightened now
1:56
Thank you Now before putting the glass tops on the frame here we have to go ahead and put the
2:17
the suction cups on the holes in the baggie labeled D and here's what they go ahead and look like
2:38
All right so here's the finished console table. It ended up looking real nice
2:41
and I do like the fact that it does go ahead and match with our coat hanger over here
2:46
So this was the perfect spot for all things and one thing to note about the feet was the floor was a little unleveled
2:52
So I kind of unscrewed the right and the left side from the front to go and even it out
2:57
So now it's gonna be a lot more leveled one modification I added to it, which I we add to like all our furniture is just gonna be like these foam pieces
3:05
These sticky pieces so we can go ahead and slide the furniture without having to worry about
3:10
Scratching from the plastic or if it has like a rubber foot or anything like that building it wasn't too bad
3:15
The hardest part would have been installing this portion and this portion, but again, I used a pillow
3:21
And then for the top part, I kind of just used my whole weight to go ahead and hold this part
3:26
Otherwise, if you had two people or if you had one more person helping you, it would have gone a lot quicker
3:31
Overall, I'm impressed with the quality of it. Definitely adds a nice touch to the home and we were needing to replace our old unit over here
3:38
So this one is perfect for this corner. But yeah, that's a quick look at the Yahi Tech console table
